Hi Gordon,
I checked the link. The contacts are the same family, but they're a
smaller version for use in connectors rather than soldered into a board.
Thanks,
Ed
On 4/28/2012 6:05 PM, Gordon Batey wrote:
Greetings to the time keepers,
We used to use those connectors way
back in the dark ages in GE Numerical
Controlled machine tool controls to connect
daughter boards to the mother board as I recall.
It is a bifurcated (?) connector and
We called them ELCO connectors.
Check out:
http://www.edac-elcoconnectors.com/
the solder eye pin near the bottom of the page might be close
*Edac #* *516-290-500*
Hope that this helps.
Gordon WA4FJC
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
