I do not know if this is the type of solution you were looking for but Wenzel builds a fantastic LNPLL.
Thomas Knox > Date: Mon, 7 May 2012 16:11:13 -0500 > From: [email protected] > To: [email protected] > Subject: Re: [time-nuts] DPLL for 10MHz > > Regarding my abilities.. regarding electronics... poor soldering is about > my limit... through hole only. That is why I was hoping there was some > off the shelf method that I could wire up with 10 MHz in from the gspdo and > from the oscillator then wire up the EFC volatge and set the required > parameters and it would adjust my oscillator to the same frequency as the > GPSDO. Sounds simple enough to me. but apparently not. I guess I need to > figure out how to do this electronics stuff...incidentally avoidance of 1) > foreign languages, 2) drafting and 3) electronics is why I chose to become > a chemical engineer.. hi hi. I once accidentally signed up for a physics > lab that involved electronics... made it through the first lab period.. was > like a fish out of water... walked immediately to administration and > dropped it. Oscilla-what I said as I skipped out of there. It was all > electrical engineers. > > > -- > Doc > > Bill Dailey > KXØO > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
