>From the Apr 2012 post: Power Supply: The NTGS50AA requires 36-75 VDC (48V nominal) and has a on-board Lucent DC-DC converter to supply the required +/-12 and +5 volts.
Serial Interfaces: Port A is RS-422 @19200 SCPI (available on the 110 pin connector on the main board) Port B is RS-232 @9600 TSIP (DB9 connector on Breakout board) LED indicators: There are 5 LED's on the breakout board that contains the DB9 connector. 1. Power 2. Not used, but switch-able via software 3. Not used, but switch-able via software 4. Lock 5. Holdover Temperature Sensor: DS1620 Rev D Jumpers: There is a 8 pin header (JP1) on the main board that would accept 4 jumpers.. I haven't tried them but it is tempting to see what happens when I enable them. On Thu, May 31, 2012 at 7:05 PM, Skip Withrow <[email protected]>wrote: > Hello time-nuts, > > Does anyone out there have information on the Trimble SCPI commands for > units manufactured for Nortel (such as the NTGS50AA)? I have a unit that > has a DB-9 that talks SCPI. The *IDN and *CLS commands work, but I have not > been able to get anything else out of it. I have not found the TSIP port > in the unit yet (if there is one). > > Thanks in advance. > > Skip Withrow > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
