On 05/06/12 12:18, Attila Kinali wrote:
On Wed, 30 May 2012 15:11:03 +0200
Attila Kinali<att...@kinali.ch> wrote:
I recently bought some Oscilloquartz 8663 from ebay and am now wondering
how to check whether they are working correctly or whether they are
out of specs.
Unfortunately, although i have a reasonable park of measurement instruments,
none of them are in the precision range that i'd need to characterize
the 8663's.
thanks everyone for the answers! I did dig a little bit trough the avilable
devices (ie those that do not cost me an arm and a leg to buy) and came
to the conclusion that i have to reformulate my requirements.
I think, the most important thing for me at the moment is to verify that
i do not have any defect devices. Defect in the sense of something other
than "does not output any signal" (these are trivial to detect).
And here i'm stuck again. What are likely defects of an OCXO? And how would
i detect them?
Oven failure. The most common failures in my experience is that they
either do not heat up or they are stuck at full heating. Sensing the
OCXO should work most of the times. Monitoring the current is another
cheap hint and measuring frequency is another. At work we measure the
frequency first, and as they open the box up they usually note if it is
hot or cold.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.