On Fri, Jun 29, 2012 at 5:37 PM, Chris Wilson <[email protected]> wrote:
> Thanks, is it worth even thinking about, or is the Kenwood add on > TCXO module more than adequate? Only reason I ask is I will be using the > rig as a driver for a microwave transverter. > The frequency stability of the oscillator in the transverter is much more important - since that's the one that's going to be multiplied many times to give you a signal to mix with the rig output. Having said this, you also have to be careful with using an external signal to drive it, since the multiplier will have the effect of seriously degrading the phase noise and so getting good results requires an extremely clean (I.E. low phase noise) source. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
