OK, so a digital 'scope is needed or, at least, with memory. On Thu, Aug 2, 2012 at 1:12 PM, Peter Bell <[email protected]> wrote:
> My guess is that it's a PP2S / "Even Second" output - that would also match > with the label... > > On Thu, Aug 2, 2012 at 5:02 PM, Azelio Boriani <[email protected] > >wrote: > > > OK, it is in the place of the PPS output... can you hook an oscilloscope > > and see if there is any output? > > > > On Thu, Aug 2, 2012 at 10:25 AM, Christoph Kopetzky <[email protected] > > >wrote: > > > > > Azelio Boriani <azelio.boriani@...> writes: > > > > > > > > > > > Why are you assuming this is a protocol or signal label? Maybe a > > > > maintenance or repair-by-exchange indication too. > > > > > > > > > > > > > Because the label is above the bnc connector on the back side of the > > 58503A > > > beside the bnc connector with an alarm label. > > > The 58503A has the single option H14. May be this is a special output > > > protocol > > > on this connector like the IRIG protocol... > > > > > > Any ideas? > > > > > > Chris > > > > > > > > > > > > _______________________________________________ > > > time-nuts mailing list -- [email protected] > > > To unsubscribe, go to > > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > > and follow the instructions there. > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
