The unit starts high and over 20 minutes comes down to 4.9999975 with 0 V on the EFC. Any voltage on pin 2 and it quits oscillating. Bert In a message dated 8/9/2012 7:06:48 P.M. Eastern Daylight Time, li...@rtty.us writes:
Hi As the unit warms up, you should be able to tell weaner it starts off above 5 or below 5 MHz. There are enough different crystal cuts that *might* be in there that checking it at turn on is the easy approach. If it starts low and is off low, the heater may be the issue. Bob On Aug 9, 2012, at 6:53 PM, ewkeh...@aol.com wrote: > Bjoern > No not able to tune it to 5 MHz. > Bert > > > In a message dated 8/9/2012 6:48:59 P.M. Eastern Daylight Time, > b...@lysator.liu.se writes: > > Hi Bert, > >> I have a FTS 1200 that is off by about 2 Hz. Have decided to take a >> closer look. Does any one have technical Information I should study >> before I >> open it up. >> Thanks >> Bert Kehren > > The efc range on my FTS 1200 goes from about -1.5Hz to +2Hz (0V to +10V). > Is your FTS1200 of even with max (or min) efc voltage? > > -- > > Björn > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.