and here is the corresponding Racal manual:
http://www.ko4bb.com/Manuals/Racal/Racal_MA2595Mc-s_Precision_Frequency_Standard.pdf
Unfortunately, the schematic of the Sulzer manual is incomplete. So, the
above manual might be useful.
Just the oven control circuits differ a little, but the oscillator stuff
appears to be exactly the same.
Adrian
paul swed schrieb:
Thanks for the pointer I have a pretty dirty pdf from some place the links
very clean.
Paul
WB8TSL
On Thu, Nov 1, 2012 at 7:24 PM, Magnus Danielson <[email protected]
wrote:
On 11/01/2012 10:27 PM, Attila Kinali wrote:
On Thu, 01 Nov 2012 21:51:21 +0100
Magnus Danielson<magnus@rubidium.**dyndns.org<[email protected]>>
wrote:
Yesterday I picked up a Sulzer 5A + 5P without batteries. It is supposed
to have 21 D-cell NiCd batteries, but today those are not easy to come
by,
NiCd Batteries still exist, but have been mostly replaced by LiIon/LiPoly
packs these days. Though, you should be still able to find NiMH batteries,
which are in most cases a drop in replacement for NiCd, if you keep
two things in mind:
1) The maximum charge current of the battery should never be exceeded.
NiCd were much more forgiving in that regard.
2) When charging finished, then the batteries need to be disconnected
unless you do a trickle charge. At least this was a problem with the
early NiMH, it might have changed in the past 15 years. Check datasheet.
3) Charge end detection for fast NiCd chargers (>1C) does not work with
NiMH as the negative Voltage slope of NiMH is not as pronounced as with
NiCd. If you have such a charger, you need to replace it with a modern
one.
Thanks for the input guys!
The manual for them both is at
http://www.ko4bb.com/Manuals/**09)_Misc_Test_Equipment/**
Sulzer_Laboratories_Model_5A_**Frequency_Standard.pdf<http://www.ko4bb.com/Manuals/09)_Misc_Test_Equipment/Sulzer_Laboratories_Model_5A_Frequency_Standard.pdf>
The 5P manual describes the charging operation, it has a 50 mA charge
current, a fast charging feature.
By the look of things, the way that the design is done, it should survive
without the battery-pack installed.
Cheers,
Magnus
______________________________**_________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/**
mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts>
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
