Your 21 ns for 1PPS and T1 does not look too bad, but the satellite received
signal strengths are too low. You should have at least four or five SS
values above 60-80. I always have at least three SS readings above 100. My
Holdover runs between 03 and 4 microseconds.
John WA4WDL
--------------------------------------------------
From: "Doug Parker" <[email protected]>
Sent: Sunday, November 11, 2012 1:36 PM
To: <[email protected]>
Subject: Re: [time-nuts] Z3805 hold-Over
Hi,
I've got a Z3805 from one of the Chineese sources and had problems with
the HP 11801 oscillator which came with it. Even after a couple of weeks
operartion it was moving vast EFC voltages with the 'Holdover Uncertainty
Predict' reaching a lowest of 19uS.
So I tried the HP oscillator from my Z3801 in the Z3805 and the daily EFC
change is back to a resonable level, but after 5 days of settling down,
the 'Holdeover Uncertainy Predict' has only got down to 10uS.and is
holding about that value.
Could some one please advise what figures they are getting. As there's
something sticking in my mind that the whole system should be lower than
6.3uS after 3 days of locked operation. Or have I been dreaming.....
I have attached a JPG of my GPSCon graph, hope it helps
thanks & 73s
Doug
G4DZU
http://www.g4dzu.com/
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
