I suppose, although interestingly there isn't anything close. It just misses
one size and the next smaller one it swims in. Although with enough epoxy...
OTOH, who cares, it's sitting up where nobody will look closely and it's not
like it's a structural element. So your suggestion looks like a winner, thanks!
Peter
On 11/26/2012 9:19 PM, Mike S wrote:
On 11/26/2012 8:51 PM, Peter Gottlieb wrote:
The antenna I got fron Nichegeek on ebay uses British Pipe Threads! Just
can't get anything here that matches it. Perhaps I should just get a
unit with regular NPT size threads?
Why not just get a pipe nipple of close size, and grind off enough of the
threads (if necessary) so you can JB Weld it in place, then go from there?
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1427 / Virus Database: 2629/5420 - Release Date: 11/26/12
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
