That is an interesting thought. Why a Master and X. Curious. They have been doing that since this all started.
On Tue, Feb 5, 2013 at 1:16 PM, paul swed <[email protected]> wrote: > There isn't a way to tell what station it is. Its just the gri rate with a > delay to the x station. > But I assume its the same actual modulator and site. > My 2 cents. > Regards > Paul. > > > On Tue, Feb 5, 2013 at 1:06 PM, Bill Riches <[email protected]>wrote: > >> OK Stan, >> >> What stations are you receiving - not GRI numbers but locations! >> >> Bill Riches >> Cape May >> >> -----Original Message----- >> From: [email protected] [mailto:[email protected]] On >> Behalf Of Stan, W1LE >> Sent: Tuesday, February 05, 2013 12:52 PM >> To: Discussion of precise time and frequency measurement >> Subject: Re: [time-nuts] Locked onto LORAN 8970 GRI Monday AM >> >> at 17:45Z, after 27 hours of continuous lock: >> freq offset is now -2.1E-12 and has been as low as -7E-13, compared to >> T'Bolt 10 MHz. >> Master station is at 59 dB, slave is at 63 dB signal strength. >> >> Stan,W1LE Cape Cod >> >> >> On 2/5/2013 12:12 PM, Bill Riches wrote: >> > Hi Paul, >> > >> > I thought I was receiving Wildwood which is 3 miles or so away but >> > apparently not. I nulled out the sig with my LFL1010 loop and get a >> > null about 30 degrees which is toward Boston but maybe it could be >> > Seneca after figuring antenna error and Mag variation. Signal >> > strength with the loop max is -40 db and null is -60 dbm. I did a >> > conversion and comparison using my icom 7600 and HP3336 sig gen. >> > Measuring with the HP 3586 did not agree with the previous method - I >> imagine the modulation screws up its reading. >> > I will play around with the Perseus later and see what that reads. So >> > - My question is - what stations are you copying? I will continue to >> > see if Wildwood comes up again. My contact with Wildwood has left the >> room! >> > >> > 73, >> > >> > Bill, WA2DVU >> > Cape May, NJU >> > >> > >> > >> > _______________________________________________ >> > time-nuts mailing list -- [email protected] To unsubscribe, go to >> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> > and follow the instructions there. >> > >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
