You can buy today the Bill Riley board and there are few boards of a change with larger SMD also today available. Once we release a final S M D version any one that wants to buy only a board that ia an option, the same will also be available in through hole. Bert
Sent from Samsung tabletJeroen Bastemeijer <[email protected]> wrote:Dear Bert, Thank you for the update! And a peek into the kitchen ;-) I guess the SMD board you mention is assembled. But I think there are people who are interested in bare boards as well.... Good luck and best regards, Jeroen On 02/06/2013 05:01 PM, [email protected] wrote: > The delay is mainly do to the fact that the promise to do the drawings did > not materialize. The counters are done and tests on variations of the D/M's > are ongoing since the noise floor is not the counter but the D/M. > Bill Riley's boards are out there and it would be nice to get some feedback > on test results, also I have explored the possibility of some one > manufacturing the board. A time nut is in the business and will be able to > supply > the SMD version of the board for $160 plus shipping if a minimum volume of > 20 get ordered. As to D/M four options will be available starting with > Bill's PCB. > I have 4 kits of my D/M and counters available and will work with some that > have the proper OCXO's and willingness to test with Time Lab since tests > with Stable 32 and Ulrich's A/V software is ongoing. If interested please > contact me off list > Recent tests by Corby has convinced me that with the four channel counter > not only cross correlation but also three corner hat is doable with one > dual mixer. The offset oscillator has to be also of high quality. > Some of the delays are due to visitors over the holidays but also the > fact that the D/M project is not the only one. Of equal or more importance is > a > home standard that can get close to a Maser using GPS Rb and the best OCXO > in the house.On the D/M the only work for us is packaging and display PIC > programming. Latest set of boards were ordered yesterday. The display is a > nice feature but not necessary. > I hope we will have the drawings in about 10 days. > Bert Kehren > > > In a message dated 2/6/2013 4:15:33 A.M. Eastern Standard Time, > [email protected] writes: > > Dear all, > > ! Did I miss something, or are we "all" waiting for more info to be > published on this system? I checked KO4BB site, but I couldn't find any > new info on this project. An update would be appreciated! > > Note: This message is written with a positive intent, not as a complaint! > > Thank you, best regards, Jeroen > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
