On Mon, Mar 18, 2013 at 04:28:32PM +0100, Volker Esper wrote: > Hi all,
> While auto calibrating the SR620 I get the message "cal error > 23" - the manual isn't that specific about this message, it > only states, that error numbers 19 to 23 are caused by Stop > TAC problems. The manual also states that error codes 19-23 are the same as the start values (n - 16), so 23 minus 16 should be the same as '7' i.e. 'stop linearity byte out of range' > However, the counter counts, but I can't do automatic > calibration any more. > Anyone having experience with that? Sorry, no further experience with that HTH, Herbert > Thanks a lot > Volker > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.