Running Auto Cal a few seconds after switching the counter on, the
calibration succeeds, though with values different from the warm ones
(who'd have thunk). After warming up, error 23 wins. I have to open it
and do the old school trouble shooting with coolant spray...
However, any advice, tip, hint would be appreciated.
Thank you
Volker
Am 18.03.2013 20:33, schrieb Volker Esper:
Am 18.03.2013 19:53, schrieb Herbert Poetzl:
page 40, search for 'stop tac'
Herbert, you are the best :-) I didn't expect the error codes in the
programming commands section.
I'm afraid it could be a hardware failure.
Thanks Volker
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
