Marc, Run your question by the Yahoo HP-Agilent group
-pete On 5/29/13, Mark C. Stephens <[email protected]> wrote: > I have recently obtained the holy grail for me - an 8566B. > They are rare as hens teeth in Australia! > > I have a 8568B as well and my phase noise floor is somewhere way down there > on that machine ;) > > However it appears the internal 10Mhz reference had died on the new (old) > 8566B. > > I haven't room on the bench due to 5 things going at once so I ran it up on > the kitchen table for the benefit of the kids - they are going to inherit > all this junk I guess :p > > I didn't plug an external standard in to check the rest of circuitry because > that's down in the workshop. > Perhaps I need a house standard output in the lounge? ;) > > Hmm Anyway, did some quick checks and I think the voltages are all there, > but my manual has the 10811 oven assembly which the Pin outs are completely > different. > > Anyone spied a 8566B manual with the Ovenaire OSC-49-61C connections? > Or even just the connections so I can work on the Ovenaire on the bench. > > The output has a 10Mhz SMB on the right side and a row of six feed through > caps on the left. > Bottom to top > > 1. Black > > 2. Orange > > 3. Purple > > 4. Red > > 5. Black > > 6. Linked to pin 5. > > I guess It won't be too hard to work out by tracing the circuit but I like > to leave the innards of these things undisturbed as much as possible. > > > Cheers, > -marki > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
