Manual is here and discusses PC interface and how to set to factory settings. I think it may be a simple matter to bring back 10MHz.

http://www.rdrelectronics.com/skip/feb/SA22c.pdf

On 6/2/2013 18:13, Robert Atkinson wrote:
Hi Magnus,
According to the datasheet 10MHz is a standard output. The Manual say you can 
change the factory setting using SSIP ( Symmetricom Serial Interface Protocol).
Unless of couse the particular units have been restricted. I don't thnik so as 
both the factory set frequency and 10MHz are coved by the standard unit.

Robert G8RPI.




________________________________
  From: Magnus Danielson <mag...@rubidium.dyndns.org>
To: time-nuts@febo.com
Sent: Sunday, 2 June 2013, 19:06
Subject: Re: [time-nuts] Cheap 9.8Mhz Sa.22c's


On 06/02/2013 07:52 PM, Mark C. Stephens wrote:
These are 9.8304Mhz, is possible to move them to 10Mhz?

http://www.ebay.com/itm/Symmetricom-SA-22c-9-8304MHz-Precision-Rubidium-Oscillator-5V-and-15V-NICE-/261223397404

I looked at it, and no. They change the core oscillator, and then you
can alter the divide power of 2 but other than that no luck.

This limits their uses outside the intended usage.

Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2242 / Virus Database: 3184/5875 - Release Date: 06/01/13





-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2242 / Virus Database: 3184/5875 - Release Date: 06/01/13

_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to