...but remember, you don't need 10kHz to get the control loop working.
Since you need a time constant of some hours, the PPS output will do.
Even more important is to use a good OCXO.
By the way: welcome to the list :-)
Volker
Am 13.06.2013 12:20, schrieb cfo:
On Wed, 12 Jun 2013 20:29:26 -0700, Bob Stewart wrote:
I saw on K3PGP's site a mention that the UT-41 GPS
receiver had a 10KHz signal on-board so I decided, why not build a GPSDO
for my "new" HP 5334B? Unfortunately the one I bought doesn't have a
10KHz point, and the board doesn't even pull out the 1PPS signal from
the chip.
As a backup plan have a look at this one *Bay 290860812674
It has 10Khz, afaik it's the one mentioned for the Miller GPSDO.
Make sure also to get the Antenna cable that belongs to it.
CFO
Denmark
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
