You might find there are either hard links on the board or different firmware?
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Murray Greenman Sent: Tuesday, 18 June 2013 12:10 PM To: [email protected] Subject: [time-nuts] Z38XX PFORTH interpreter question Hi, Has anyone made further progress in understanding the PFORTH commands? I find with my Z3815A (with an E1938A hockey puck oscillator installed) that the command 'puck' returns: a= -6.305066e-13 b= 0.000000e00 a/d = 1.600000e+01 puck communication is alive puck warm= 1 puck EFC ADC err= 0 status1 byte= 1 status2 byte= 0 What fun! I wonder what the three variables are and can one change them? As a separate but related question, I've just swapped out a failed MTI 260 OCXO from this Z3815A and fitted in its place the older E1938A hockey puck. The problem I have is that the EFC sense seems to be reversed. Does anyone know how to change this, either by sending a PFORTH command or otherwise? It would be great to get the Z3815A going again. 73, Murray ZL1BPU _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
