The cable is a straight DTE-DCE one. BR is 9600 (8O1).
The yellow LED won't go off until it's communicating with the base
station through the rear 110-pin connector.
Is it connected to an on board COM or through an USB adapter?
On COM1 LH 3.10 starts straight without any command line switches or
other fiddlings (just a warning message about "no COM1 data seen", which
disappears quickly).
On 7/5/2013 10:55 PM, Jim Sanford wrote:
All:
I have my new Nortel unit powered up. I have been unsuccessful at
getting it to communicate with Lady Heather.
I have tried both 19K2, 7, O 1 and 9K6, 8, N, 1 on the serial port to no
avail.
I tried the command line switch to wake up Nortel units wit both sets of
serial parameters, to no avail.
The instance of Lady Heather which goes out to KE5FX site works, so I
presume I have a correct installation of Lady Heather.
The Nortel appears to go through normal power up display on power up.
Then it lights the yellow "no communication" LED. Once I hooked up an
antenna, within a few minutes, the green LOCK LED came on. It appears
that the Nortel is working.
Is there something I'm missing about making these two play nicely
together??
Thanks & 73,
Jim
[email protected]
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
