I don't have a GPS-18 in front of me, and I'm modifying some software
remotely, and I ran across an issue that someone on this list probably
knows off the top of their head.
Does the GPS-18 put out 1pps pulses even if it hasn't got a fix yet?
That is, when you apply power, does it just start putting out 1pps
pulses (at some random phase), and then when it gets a fix, it snaps to
the correct timing.
The manual says that it puts out 1pps pulses until power is removed, so
I assume that when the GPS signal goes away, it keeps on as best it can.
I would assume that the clock isn't great, but it's reasonably close
to 1pps.
What's the behavior when it reacquires? Say the free-running 1pps is
something like 1.1 Hz, so in 10 seconds, we've got an extra 1pps. Does
it then skip pulses, or what?
And a sort of background hardware question...
The manual is also not very forthcoming on the electrical
characteristics.. is it a pull up with a switch pulling it down to
ground? or does it source significant current? That is, if you wanted to
"wire or" the output from the GPS-18 with another 1pps source, would it
be "diodes" or "resistors" you'd use.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
