Yes thanks ran across it. Skimmed it. Did not think I would be doing it. :-)
On Fri, Jul 26, 2013 at 1:15 PM, Ed Palmer <[email protected]> wrote: > Hi Paul, > > Did you see this page that talks about tweaking the 10811 oven controller? > > http://www.realhamradio.com/**z3801a-turning-point.htm<http://www.realhamradio.com/z3801a-turning-point.htm> > > Ed > > > > On 7/26/2013 10:47 AM, paul swed wrote: > >> sounds like time to add a R across the temp set R. That will lower the R >> and raise the temp. Its also easy to actually do. >> Thanks >> >> >> On Fri, Jul 26, 2013 at 12:08 PM, Bob Camp <[email protected]> wrote: >> >> Hi >>> >>> HP spec'd the crystals to be at a < 1x10^-8 / C slope at the marked >>> temperature on the crystal. The center of the curve should be in the >>> vicinity of 90C. >>> >>> You are ~ -4.5 x 10^-6 low, so that would be > 10 C away from that point >>> going cold and a bit further going hot. Since the oven is at ~80C, it's >>> not >>> to hot… >>> >>> Bob >>> >>> >>> >>> > ______________________________**_________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/** > mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
