Hi Alan,
Just did this. Less than 0.005 Hz.
To really fine tune it, you need to used the C-field adjustment pin.
This circuit is simple. A Linear Technology LT1236 precision 5V
regulator and a 10 K linear 20+ turn pot. You can get a sample of the
chip free from Linear Technology.
Circuit LPRO power voltage -----LT1236---- POT---- GND
| |____ >CFIELD PIN
GND
On the adjustment, you tweak it and wait about 10 minutes to see what
it does. Then tweak again.
Do this with the LPRO in its enclosure after it has run at least a day.
Regards,
Brian
On 8/16/2013 13:41, Alan Kamrowski II wrote:
Hi Everyone,
I'm going to try to calibrate my LPRO 101 to a GPS 1pps signal.
Does anyone know what "one turn clockwise" of the c field adjustment pot
will do to the signal in terms of ppb ?
Thanks,
Alan
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2242 / Virus Database: 3211/6082 - Release Date: 08/16/13
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2242 / Virus Database: 3211/6082 - Release Date: 08/16/13
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
