Hi, I built a number of the air spaced patch antennas, < http://www.express-builder.com/docs/gpsant/ >, several years ago for APRS mobiles and even with older GPS modules (Garmin), they gave usable performance.
Robert G8RPI. ________________________________ From: Attila Kinali <[email protected]> To: Discussion of precise time and frequency measurement <[email protected]> Sent: Sunday, 29 September 2013, 18:38 Subject: Re: [time-nuts] DIY GPS antenna... On Sun, 29 Sep 2013 19:00:54 +0200 Attila Kinali <[email protected]> wrote: > > That sounds like a pinwheel antenna. I've wondered how hard it would > > be to build one, but I've never seen a DIY version and the math is way > > beyond me. The only commercial version that I've seen is from > > Novatel. Do they control all the patents? > > Building one should be fairly easy. Just use standard PCB fabrication > and you can build the whole structure with high accuracy. The design > itself is the hard thing to come up with. I think, for us mere mortals > the only way to come up with something half decent is to use a genetic > algorithm that goes trough various designs and selects the best one. > Unfortunately, i'm not aware of any antenna design software suitable > for such a task. BTW: if you want to build your own GPS antenna, the easiest designs are * Patch antenna If you don't use any ceramic material, it's just two rectangular copper plates ontop of eachother with some spacers, although bit big. There are IIRC closed formulas to calculate the size of the patch and the position of the feed. One example of this kind is [1] * Cross-Dipole antenna Like the patch antenna, this one follows the idea of having two arms at a right angle, which differ slightly in length. Very easy to calculate, but it becomes large and you need more free space around it than the patch antenna and probably a ground plate as reflector as well. If you dont feel like building this one out of wires for the fear of getting the measures wrong, make a PCB design with a slit in the middle to put two PCBs at a right angle together. The traces on the PCB then form the antenna which you just have to solder together. * Helical antenna I haven't had a look at those, but i guess they are not too difficult to calculate (there are at least a few ham radio designs out there and i'm sure Rothammel has the formulas). Some form of platic tube could form as a base material where you wind wire around it. The clasic 4 wire helical design with a rigid coax core is well known and there are quite a few desscriptions out there, e.g. [2] And if you are at JPL, you are free to but this antenna into a salad bowl ;-) I would probably prefer the patch or cross dipol antenna made out of PCB material, such that the bottom of the "ground plate" PCB would contain the LNA. Attila Kinali [1] http://www.express-builder.com/docs/gpsant/ [2] http://lea.hamradio.si/~s53mv/navsats/analog.html -- 1.) Write everything down. 2.) Reduce to the essential. 3.) Stop and question. -- The Habits of Highly Boring People, Chris Sauve _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
