Hi Matthieu I don't know if anybody else can help, but although I do have an older copy of Labview it's been a while since I've used it and don't think I've even tried it with the FCA3100. I have tried activating talk-only mode using the NI-Max interface but didn't have any sucess with that. Now that we have the DLLs to run the FCA3100 in HP5313x mode using TimeLab I don't expect to be revisiting the FCA3100 talk only issues in the near future anyway, but would certainly be interested to hear if you have any success. Regards Nigel GM8PZR In a message dated 15/10/2013 19:30:56 GMT Daylight Time, [email protected] writes:
Hi there, Just discovered your postes today. I am also getting trouble with a tektronics FCA3100 in talk only mode. I'm using NI Labview and NI GPIB. While it works fine to get measures as up as 1000measure/s using FETCH, I'd like to have the talk only mode activated? So far, what is not working is the following commands : CONF:FREQ 1E7,1 FREQ:REGR OFF FORM:BORD NORM FORM:TINF 0 FORMAT PACK ACQ:APER TRIG:COUNT 1 ARM:COUN INF SYST:TALK ON INIT:CONT ON Then, I get no data with the next read instruction. I don't even know if the data are staored elsewhere in on of the memory segment of the apparatus... Getting help on this would be great. I'll also tell you as soon as I find something... regards, Matthieu _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
