Björn, If you can't find a black box that does this, just use two serial ports: Rx from one and the Tx from the other. On the software side it means opening two devices, but that shouldn't be hard to handle.
Note bb-elec.com used to make a cute 4-port serial concentrator that would allow you to configure different baud rates in/out, but I see that's no longer a current product. Of course you could do all this with a micro or SBC, but I assume you're looking for a turn-key device rather than a homebrew project. /tvb ----- Original Message ----- From: ""Björn"" <[email protected]> To: <[email protected]> Sent: Friday, December 06, 2013 4:14 PM Subject: [time-nuts] OT : different Rx and Tx baud rate on same port Hi, I am looking for current serial adapters that support split baud rates. That is different input and output baud rate. Grateful for suggestions! kind regards, Björn _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
