the ones I have seen take the place of a crimp pin to be inserted
into the connector to maintain moisture integrity.
With the length, it looks like it would take the place of a wire in
the water seal / strain relief, if only one wire were to be used.
73
Glenn
Never seen one like that before,
At 09:52 PM 12/9/2013, you wrote:
Take a look at ebay auction 261315795465. It's a mil-spec connector
and I don't see any way for the connector pins to come out. It
looks like it's probably pressure tight. You can see the blue
plastic pin in the third picture. It's almost like it has something
to do with the rubber strain relief/enviro shield, but I dunno what.
Bob
>________________________________
> From: J. Forster <[email protected]>
>To: Bob Stewart <[email protected]>; Discussion of precise time and
frequency measurement <[email protected]>
>Sent: Monday, December 9, 2013 8:33 PM
>Subject: Re: [time-nuts] MS3106R10SL-4S connector question
>
>
>If the contacts are loose and individually extractable/insertable, the pin
>is probably a dummy pin to substitute for the more expensive brass/gold
>pins. This is so the rubber does not distorted over time.
>
>-John
>
>
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
