Corby I pulled the a15 board and there are no resistors, just a short across what would have been r19 and 21. So I suspect that there is to much current actually. Further speculation is that when the pot is toward ground more current flows from what I see in the schematic. I may guess that more current equals lower frequency? Regards Paul.
On Thu, Jan 2, 2014 at 4:22 PM, <cdel...@juno.com> wrote: > Paul the C-field current is the same for the 5061A and 5060A. > > The 5060A C-field pot has LOTS more range than the later 5061A where they > installed resistors on each side of the pot to reduce the range. > > Corby > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.