Corby Having a good time tinkering with the 5061. Did change the resistors for the cfield regulator so that its much close to the schematic and am experimenting with that. The system does seems to be able to be tuned through a stable position that reduces the drift to 2 min/10ns drift and the CS is slow compared to the 5065 RB set to loran C when its on the air. I do have a older synth div board. No thumbwheel switches. It appears to me to be jumpered at 8634. I think that may be wrong. The book says 2095 for atomic time. Appreciate your thoughts. Regards Paul
On Thu, Jan 2, 2014 at 4:52 PM, paul swed <paulsw...@gmail.com> wrote: > Corby > I pulled the a15 board and there are no resistors, just a short across > what would have been r19 and 21. So I suspect that there is to much current > actually. Further speculation is that when the pot is toward ground more > current flows from what I see in the schematic. > I may guess that more current equals lower frequency? > Regards > Paul. > > > On Thu, Jan 2, 2014 at 4:22 PM, <cdel...@juno.com> wrote: > >> Paul the C-field current is the same for the 5061A and 5060A. >> >> The 5060A C-field pot has LOTS more range than the later 5061A where they >> installed resistors on each side of the pot to reduce the range. >> >> Corby >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.