Right, I should be able to get that from the TIM-TP message, but then what do I do with it? Not sure how I can apply a picosecond correction in this configuration short of adding a programmable delay line chip that would cost more than the GPS receiver did. -- eric
On Fri, Mar 28, 2014 at 6:40 PM, Chris Albertson <albertson.ch...@gmail.com>wrote: > On Fri, Mar 28, 2014 at 5:15 PM, Eric Williams <wd6...@gmail.com> wrote: > > > OK, now I understand the reference, but not the significance in this > > context. The sawtooth error is below the resolution of the counter here. > > > I think you are right. It hardly matters for your application. I think > you said this was going to drive a wall clock? > > But on the other hand using sawtooth is free and does not add to the parts > count. All you do is read some serial data. > > -- > > Chris Albertson > Redondo Beach, California > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.