On Fri, Mar 28, 2014 at 6:56 PM, Eric Williams <[email protected]> wrote:
> Right, I should be able to get that from the TIM-TP message, but then what > do I do with it? Not sure how I can apply a picosecond correction in this > configuration short of adding a programmable delay line chip that would > cost more than the GPS receiver did. After you measure relative phase from PPS to local oscillator and convert that to nanoseconds you add the sawtooth correction. (I may have the sign wrong and you subtract it.) If you are already decoding serial data to drive the numbers on your clock it just adds a few more lines of code. -- Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
