Claude,
your output is a square wave on 50 Ohm as write close the connector. Use this filter to have a clean sinewave output. http://www.timeok.it/files/5_and_10mhz_low_pass_notch_filter.pdf Luciano www.timeok.it On Thu 17/04/14 7:32 AM , Claude Fender wrote:Hello List, I've recently bought a Quartzlock 10A R (rubidium). Does anyone has experience with this unit? My unit has two outputs with no options. The problem is the shape of the waveform (see attachments), it's the same shape for the two outputs. When I connect an output directly to the oscilloscope, the shape is nearly "squared" and when I use a probe, the shape is nearly "sine" ! When I send a 10 MHz signal from a generator, the waveform is a clean sine with or whithout the probe. So what signal should I except from this rubidium ? Or most probably, what is wrong with my use of the oscilloscope ? (The frequency is ok by the way (+2E-10) and I didn't open the case yet) Thanks for any advice Claude _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts [1] and follow the instructions there. ------------------------- Message sent via Atmail Open - http://atmail.org/ Links: ------ [1] http://webmail.timeok.it/parse.php?redirect=https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
