I have the adafruit and a ublox-6T each mated to raspberry pi's. With NTP they are essentially indistinguishable. I have something other than NTP in mind for the 6Tpi.
Sent from my iPad > On May 9, 2014, at 9:32 PM, Brian Lloyd <[email protected]> wrote: > > On Fri, May 9, 2014 at 8:49 PM, Chris Albertson > <[email protected]>wrote: > >>> On Fri, May 9, 2014 at 1:55 PM, Brian Lloyd <[email protected]> wrote: >>> >>> Has anyone here made NTP run on BBB? My plan is to run NTP disciplined by >>> my Trimble Thunderbolt on BBB. >> >> >> NTP is likely already installed on the BBB. It ships with the BBB. > > > That may be the case for the Angstrom distro but it is not the case for the > Debian distro, which seems to be the future direction of BBB. > > >> Some >> configuration is needed to enable the service. Do this first and verify >> you can run using Internet pool servers. Then after this is running you >> physically connect your GPS then add lines in NTP's config file telling NTP >> you have added another ref. clock. > > This link: > > http://the8thlayerof.net/2013/12/08/adafruit-ultimate-gps-cape-creating-custom-beaglebone-black-device-tree-overlay-file/ > > Seems to have the bulk of the requisite information including building a > GPS cape using the Adafruit GPS module. See: > > https://www.adafruit.com/product/746 > > This isn't a timing receiver but would probably be adequate for NTP. But > since I already have a T-bolt I figured I would use that as my timing > source. > > -- > Brian Lloyd, WB6RQN/J79BPL > 706 Flightline Drive > Spring Branch, TX 78070 > [email protected] > +1.916.877.5067 > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
