Ernie, I'm having issues right now, I need to find my adapter cable as the one I have right now is the wrong pin spacing. I did trace the lines on the PCB and it appears to be the same as the Resolution-T / Lassen / other Trimble pinouts...
Just FYI, I couldn't find a valid link to the 3.41 software since ublox bought them and they only have a newer version which I don't think supports the old binary protocol, they only support NMEA (supposedly)... It probably wouldn't hurt to try them out later though. I do not know what language the module will start out in... I did find an older version on the archive.org website, link is below: https://web.archive.org/web/20070227050436/http://isuite.fastrax.fi/download/gpswb/Setup331.exe If you dig around on some newer pages there is also a link to a firmware download and the updater software that works. The pinout for the board *should* be: 1 - Antenna Input (5v - 3V I guess) 2 - Prime Power - 3.3V 3 - TXD 4 - Reserved 5 - RXD 6 - 1PPS 7 - No Connect 8 - GND If you hold the module so the SMA is on the LEFT (bottom side), and the pins are on the far RIGHT facing up. GND - 8 7 - NC PPS - 6 5 - RX RES - 4 3 - TX PWR - 2 1 - ANT For verification, if you look closely you can see the trace going out from Pin-2 Y's up and down. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
