Bob,
I was being a bit lazy. The 15' distance gets from a couple of spots in
the room with my systems and lab, and also is already terminated, and
there is no issue with the power since it would be totally contained in
the unit.
But your suggestion and some work making the cables would work best.
To you and Hal who suggested it, is this unit suitable for outputing a
1pps timing signal? Wouldn't the long serial option Hal suggestion mess
that up, vs. using this method to put the Fastax as close as possible to
a system which which would have the systems gpio and serial ports attached?
Thanks to you both for answering.
jim
On 7/1/2014 9:30 PM, Bob Stewart wrote:
Jim,
Are you trying to find out how to hook up a receiver in your
office/radio room to an antenna that is some ways away? Or are you
specifically trying to remotely hook up a receiver near your antenna?
If the former, just use RG-6, like for cable TV, with adapters on each
end. RG-6 has such low loss that the impedance change is not an
issue. I've got a 30+ ft run up to the attic to a cheap GPS puck
antenna for my setup. Others have much longer runs and it works OK.
Bob
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
