The "GPS Health" menu choice never really did anything. It will always say "Doing position fixes, error code: 1". However, the GPS Firmware and Signal Strength menus should report back proper information.
Can you elaborate on "it does not set the right time"? Is it some random time, or is it off by some fixed general offset (like 1 hour)? Do the Tracking & Lock LEDs light up with the new receiver? > Hi all! > Have a Datum ts2100 that had a failed gps receiver. Found a replacement as > a new "clone". The ts2100 with the new receiver does not set the right > time, however, it does know where it is, reports the gps firmware version > and gives satellite information. Prior to this, the only message that I > could get regarding the gps receiver was "gps engine busy". The ts2100 > never illuminates the "lock" or "tracking" led's on the front panel. > When checking the menu available from the front panel, in the timing > section, at the "gps health" prompt, the ts2100 reports the error "gps > doing fixes error code 41" > A google search reveals absolutely nothing. > Norm n3ykf _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
