Jason
Re: Datum TS2100
I have only recently obtained a Datum 2100 GPS - its working fine, but it
has been suggested that the Oscillator is not disciplined by the GPS - can
somebody confirm this ? A brief look inside has established that it has a
Trimble GPS unit, which would seem to be the same as per your discussion. Is
it possible to obtain the Technical Manual for this equipment ?
Thanks
Roy
-----Original Message-----
From: Jason Rabel
Sent: Saturday, July 26, 2014 3:04 PM
To: [email protected]
Subject: Re: [time-nuts] Datum ts2100 gps error code 41: New clone ace III
I also have a pair of small boards that I don't have any info on.
PCB says Trimble, 39818-00-C. The 00 is written in by hand.
There is a big chip on the bottom that says Trimble. 144 quad
flatpack.
It's got more stuff on the chip, but I can't read it.
I compared against my Trimble modules... Those are ACE-III receivers.
They are newer models (but backwards compatible) with the SveeSix... They
are also what you *usually* find in a Tymserve TS2100.
Don't get rid of them, they are very hard to find these days! If you
don't want them, contact me off-list if you want to sell them!
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
