I'm not familiar with the 10811-60212 variant, but I have a -60168 single oven part whose 6-pin connector is wired like this:
BLK Gnd RED Oscillator power +11.5-13V BLK Gnd YEL Oven monitor GRN Oven power +20-30V BLU Oven ground The coax connectors are probably SMB (J1=EFC, J2=10 MHz out). Schematics will be comparable to the rest of the 10811 series, as seen in http://www.leapsecond.com/museum/10811a/10811a.pdf . The red and gray wires probably go to the outer oven and its associated thermistor, if the -60212 is a DOCXO. Sounds like it is from what you're saying. No guarantee that the pinout above will work with your oscillator, so use caution when powering it up for the first time. -- john, KE5FX Miles Design LLC > -----Original Message----- > From: time-nuts [mailto:[email protected]] On Behalf Of > [email protected] > Sent: Friday, October 10, 2014 4:32 PM > To: [email protected] > Subject: [time-nuts] HP10811-60212-B Pinouts. > > Hi All, > > I recently picked up an HP10811-60212-B oscillator. However I don't > happen to have the pinouts for this device. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
