Hi Well, been there / done that in this case. The 100EP noise floor is nothing exciting. It’s 1/F corner isn’t very impressive either.
Bob On Oct 16, 2014, at 12:23 PM, Gerhard Hoffmann <[email protected]> wrote: > Am 16.10.2014 um 02:02 schrieb Bert Kehren via time-nuts: >> Take a look at Potato chips yes Potato I have used them with good results >> Bert Kehren >> 330551715157 > They don't impress me much. Yes, they can drive my 0.6pF active probes > without a > problem, but connecting just one of their own inputs to an output slows it > down > to half speed. The word "line driver" for their '125 seems somewhat > optimistic. > Propagation delay vs. load capacitance could be a problem with them. > > >> In a message dated 10/15/2014 6:44:47 P.M. Eastern Daylight Time, >> [email protected] writes: >> >> Hi >> >> Most ECL families have more trouble with 1/F noise than fast silicon >> saturated logic. That makes them poor candidates for this sort of thing. > > Motorola's Mosaic3 process was really ugly, and with PECL you get all the VCC > noise > unattenuated to the output in the high state. But is is seldom that MOSFETs > outdo > bipolars wrt 1/f corners. I think I'll give the 100EP a try. > > Gerhard > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
