Usually "phase detectors" (we prefer to call them Time Interval Analysers) have data interfaces (RS232, GPIB, LAN). If you build your own then the interface is up to you: usually an RS232 is the best choice. The software to use: take a look at the Miles' TimeLab <www.ke5fx.com/timelab/readme.htm> or <http://www.thegleam.com/ke5fx/>. Of course, in case of the GPIB, you also will need an adapter: GPIB/USB or GPIB/LAN but the less expensive GPIB/RS232 maybe a good choice.
On Sat, Nov 1, 2014 at 2:29 PM, Anthony Roby <[email protected]> wrote: > I've been reading a lot about ADEV and following the threads on the list, > particularly Karen's in-flight thread. What I haven't come across is a simple > explanation of the basic setup required to go about collecting the data. > John Miles referenced this page http://www.ke5fx.com/tpll.htm, and the simple > setup at the bottom of the page looks like a reasonable place to start. > Seems that I'd need to acquire a phase detector and build or buy some filters > and the amp. I can probably figure that out, but how do I get the data into > a PC? Is there a basic hardware and software setup that someone could point > me to or recommend? > > Thanks > > Anthony > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
