Hi I got a chance to look at phase noise today. I’ll try to post the plots later. Quick summary:
10 MHz - ugly. Lots of spurs, many of them close in. Poor phase noise floor. 15 MHz - pretty good. Noise floor is not as good as a TBolt (by 5 to 15 db). Far fewer spurs than the 10 MHz, fewer spurs than the TBolts I’ve looked at. ADEV on a short run looks better than an un-tuned TBolt. I’ll need a much longer run to see what it’s really doing. Bob > On Nov 3, 2014, at 1:20 PM, GandalfG8--- via time-nuts <[email protected]> > wrote: > > Ah, that's interesting, perhaps it wasn't me after all then. > > Did you have the same flashing ON light symptoms? > > Regards > > Nigel > GM8PZR > > > In a message dated 03/11/2014 17:56:56 GMT Standard Time, > [email protected] writes: > > >> It turns out this is what happens if you switch the "Output Level" from > 17 >> to 23, obviously an advisory indication to draw attention to the higher >> output. Switching it back reduces the level, as expected, and returns the >> LED function to normal. Phew:-) > >> I can't remember switching it but don't suppose it arrived like that so >> guess I must have done. > > My pair came with Ref-0 set at 17 and Ref-1 at 23. > > > -- > These are my opinions. I hate spam. > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
