If they are straight wired pin 1 to pin 1, pin 2 to pin 2, etc, they will
not work.
----- Original Message -----
From: "Don Latham" <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Tuesday, November 04, 2014 1:23 AM
Subject: Re: [time-nuts] Z3812 Diag port data? RE: time-nuts Digest, Vol
124, Issue 26
Bob and all: Haven't hookedd upmy units yet. Marlon P Jones (MPJA) has
some
Real Cheap 15 pin m-m cables that are 1 ft long, might be useful. no
clipped
pins, whatever they're for. I don't think many of us want to hot-plug that
cable?
Don
Bob Camp
My boxes were flakey at first. What I finally figured out was that the
interface cable was the weak link. I’d bet that the short pins don’t mate
quite well enough with their sockets. After some wiggling all has been ok
for
a while.
--
"The power of accurate observation is commonly called cynicism by those
who
have not got it."
-George Bernard Shaw
Dr. Don Latham AJ7LL
Six Mile Systems LLC
17850 Six Mile Road
Huson, MT, 59846
mail: POBox 404
Frenchtown MT 59834-0404
VOX 406-626-4304
Skype: buffler2
www.lightningforensics.com
www.sixmilesystems.com
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
