Hi A bit over 2A for the pair at turn on. About 1A for the pair after warmup.
Bob > On Nov 21, 2014, at 6:23 PM, Graham <planoph...@aei.ca> wrote: > > Just to clarify, each unit (no more than 2 and steady about 1.1A) or both > units together? > > cheers, Graham ve3gtc > > On 2014-11-21 12:50, Anthony Roby wrote: >> I have been using a Universal 24V 5A DC Switching Power Supply from eBay. I >> have not seen my units draw more than 2A each - steady state is about 1.1A. >> >> Anthony >> >> -----Original Message----- >> From: time-nuts [mailto:time-nuts-boun...@febo.com] On Behalf Of >> planoph...@aei.ca >> Sent: Friday, November 21, 2014 11:25 AM >> To: Discussion of precise time and frequency measurement >> Subject: [time-nuts] Lucent KS-24361 24V DC power requirements >> >> Good day all, >> >> I have been following the discussions as best as I could. I recell seeing >> the question asked or at least theorized as to what is the power >> requirements of these units - either individually or together. >> >> I have reviewed all messages or at least all that I can find in these >> threads but I couldn't find a definitive answer unless of course the answer >> is in one of the responses hiding where I haven't looked. >> >> I purchased a set of these modules and they are currently in transit but I >> don't have a 24V DC supply at the moment. >> >> So, in order to try and get ahead before the arrival of these modules I >> would like to at least plan out if not get a suitable power supply ready. I >> don't want to over specify by too much and worse yet, under specify. >> >> Has anyone actually made any power used measurements of these modules? 2A >> average, 4A peak? Somewhere inbetween or more? >> >> cheers, Graham ve3gtc >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.