Hi The thing that looks like a second oven on that unit really is not one it is a boost heater. It should be off under normal conditions.
Assuming it is off, it is not the problem. Next thing to check is the input power. Bob Sent from my iPhone > On Nov 26, 2014, at 9:53 PM, d...@irtelemetrics.com wrote: > > Hi Bob, > > Yeah it did. This is running as part of one of Bob Stewart's GPSDO's. It's > been up for about two weeks now. The log indicated there was a phase jump > compared to the GPS PPS input. EFC made a jump to correct for it. A few hours > later, it made a small jump back in the other direction, with a corresponding > phase and EFC correction there also. By the phase jump, I would have though > it was the crystal doing something. But the fact that it showed up in the > oven monitor voltage also has me a bit worried. > > The outer oven controller didn't show anything similar. > > I've been wracking my brain about what could be causing this. It's way to > sudden to be anything one would expect from a normal analog circuit. The room > temp cycles are visible, but are nice and smooth compared to this. It makes > me think there is something mechanical going on. > > Who knows, maybe the crystal changing affects power dissipation from the > oven? Still trying to figure out exactly how much of a change in oven power > this is, but I suspect it's very small. With the three transistors in > darlington and 100K resistor feeding the base, a 1mV change on the inner oven > controller differential amp would indeed be a small change. > I was thinking, I also need to rule out the power supply. But, I need to > setup a voltage divider to get that to within the ADC input range... > > Dan > >> >> Hi >> >> Did the frequency shift at the same time? If not, the first suspect would be >> the data collection system. >> Bob >> >> > On Nov 26, 2014, at 11:00 AM, Dan Kemppainen <d...@irtelemetrics.com> >> > wrote: >> > > Hi All, >> > > I've been playing with some double oven HP10811's. I've been monitoring >> > > the internal oven feedback vs. temperature and noticed something >> > > interesting last night. There was a sudden step change in internal oven >> > > feedback voltage. This is the voltage coming from the amplifier >> > > monitoring the bridge that feeds the heater transistors. > > The step >> > > change was on the order of two or three times as large as normal swings >> > > caused by the furnace cycling in the house. The voltage was being >> > > monitored by a 8Ch ADC card. All of the other voltages on that card were >> > > stable. > > The jump was very small. I don't recall exactly (Not near >> > > that unit right now), but somewhere around a mV or less. But it was very >> > > sudden and compared to everything else on that line, or other voltages >> > > being monitored. > > I'm wondering if there is something going on in >> > > there that may require attention. Bad solder, cracked trace, bad >> > > component??? >> > > Any idea what might have caused this? >> > > Has anyone seen anything similar? >> > > Thanks, >> > Dan >> > > _______________________________________________ >> > time-nuts mailing list -- time-nuts@febo.com >> > To unsubscribe, go to >> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
