Eds Right I did see it used to turn square waves into sine waves. I will have to try that. But I am very happy with it even as a simple transformer. Thats what surprised me something that goes nicely all the way down below 60 KHz. I have to tell you I have been using lots of things that I have found for 60 and 100 Khz. This offers me some consistency with actual documentation. Its hard to find LF things these days. Beats un-soldering from a board also.
Bob granted these can be used for twisted pair. Unshielded also. What about radiation at 5 or 10 Mhz. Granted there is shielded twisted pairs. Regards Paul WB8TSL On Sun, Dec 14, 2014 at 4:20 PM, Jim Lux <[email protected]> wrote: > > On 12/14/14, 10:41 AM, paul swed wrote: > >> Well with zero effort the spec sheet. Bob indeed there are common mode >> chokes in them. Jeeze a lot in 1 package along with center taps. >> Regards >> Paul >> WB8TSL >> >> > > I've seen a lot of MiniCircuits BNC 10.7 MHz BPFs used in equipment racks > over the years as a sort of "get rid of trash" filter (at least I'm sure > that's what the person who bought them thought). Not so hot in terms of > phase vs temperature (elliptic filter, 2 MHz wide, centered at 10.7), but > probably pretty good at knocking down harmonics and such. > > BBP-10.7+ ... $41 each. > http://www.minicircuits.com/pdfs/BBP-10.7+.pdf > > > Interestingly, only 26 dB rejection at 20 MHz. Must be in the middle of > the first "bounce" of the response.. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/ > mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
