Hi:
You can see the 4 nodes on the Chinese Spouting bowl in my video at:
https://www.youtube.com/watch?v=k68w3OrPztE
When I got it from Cliff Stoll he had recommended using a wet towel to keep the bowl from moving but that damped the
vibrations.
I got 4 stick-on feet and placed them at the nodes seen in the video above and
it works great.
If the bowl is supported anywhere but the nodes the oscillations are damped,
just like for a crystal.
http://www.ted.com/talks/clifford_stoll_on_everything
https://en.wikipedia.org/wiki/Clifford_Stoll
http://www.kleinbottle.com/ <- it looks like he no longer carries the spouting
bowl.
Mail_Attachment --
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.end2partygovernment.com/2012Issues.html
http://www.prc68.com/I/DietNutrition.html
Bob Camp wrote:
Hi
The mounting points are the standard locations for a flexure bar running the
resonance along it’s length. The sandwich blank is a bit unique.
The normal gate feedback style circuits will get the crystal running. The
impedance will be quite high, so you will need a bit of gain. At low
frequencies, a CMOS input op-amp will do the trick.
Bob
On Jan 10, 2015, at 12:24 PM, David J Taylor <[email protected]>
wrote:
Hi David yes I think I have seen similar but not as low as that. If you
compare the suspension points the different vibrational mode should
obvious.....the suspension point is at a node. I think some of these are
quite difficult to excite, I have not seen any suggested circuits but I have
not looked too hard.
Alan
====================================
I uploaded a couple of pictures taken with the 'phone.
http://www.satsignal.eu/Radio/2015-01-10-1700-54-crop.jpg
http://www.satsignal.eu/Radio/2015-01-10-1702-51-crop.jpg
The first photo shows the size and mounting points of the crystal. The crystal
itself appears to be a two-layer structure. The second photo shows a detail of
one of the mounting points. The gold plating appears to have been scraped away
at the edge, and some sort of solder join made at the edge. I might be able to
do a better image with a different camera, but I don't know.
Hope that is of some interest.
David
--
SatSignal Software - Quality software written to your requirements
Web: http://www.satsignal.eu
Email: [email protected]
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
