Hello Nuts, I have been playing a bit tuning a Thunderbolt with Lady Heather and now have more questions than answers. The collective time-nut brain would be appreciated.
1. Using the '&' command I can change the damping and time constant in LH. Are these values immediately transferred to the TB? 2. Do I have to use the LH 'e' command to permenantly save new damping and time constant values to the TB? 3. After using the '&' and 'e' command the lock-in behaviour of the TB does not seem to change. Is this normal behaviour? Is one set of values used when locking and the adjusted values used once it is phase locked? 4.Is there some way to read out the values stored in the TB? When I use the 'e' command on the TB, change values in LH, then restart LH and the TB I see the last values given to LH, and not what I thought was saved with the 'e' command. 5. If the TB is placed in hold mode and the DAC set to 0.0 volts it actually goes to 0.2 volts (min is at -5, max is at +5, and iv is 0.0 which it actually starts at on power up). Anyone know why? Thanks in advance for any guidance! Regards, Skip Withrow _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.