Hi Is this for a business or for a basement?
Are you looking for new self contained gear or combinations of used gear? Is a cross comparison device ok or do you need a stand alone device? How low do you need to go how fast? Is -190 dbc/ Hz low enough? Is a 24 hour run to long? Lots of variables…. Bob > On Apr 22, 2015, at 10:07 AM, Vasco Soares <[email protected]> wrote: > > Hi All, > > > > I'm searching for the less expensive signal analyzer to perform phase noise > measurements on OCXO's. There is no need to go above 400 MHz - 1 GHz. I'm > particularly interested on low frequency offset and good close in phase noise > specs. Any recommendations? > > > > Best regards, > > Vasco Soares > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
