The Phase noise floor (~-143dBc/Hz @ 1kHz) of the 10MHz output of that divider
is about 17dBc/Hz higher than either the LTC6957-4 (demo board) or the
Holzworth HX2410 (both ~ -160dBc/Hz @ 1kHz).All measured with a 10MHz +14dBm
input signal.For offsets below a few Hz shielding of the circuitry from air
currents and reducing temperature fluctuations experienced by the circuitry is
essential for accurate phase noise measurements.
Bruce
On Wednesday, 6 May 2015 2:36 PM, Richard (Rick) Karlquist
<[email protected]> wrote:
On 4/26/2015 3:51 AM, Bryan _ wrote:
> All:
>
> P
I was looking at the project from David partridges web site
http://www.perdrix.co.uk/FrequencyDivider/index.html
> -=Bryan=-
> _______________________________________________
>
This is a comparator based circuit. This will give
you worse performance than just about anything else,
but it may be good enough anyway.
Rick Karlquist N6RK
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
