Many of the Navman T60-D125 units are floating around on various sales sites. Unfortunately, some come with built in problems and poor documentation.
Here are some things that I have found in working with one for the past year. 1) If you have found that communicating with the unit on the development board over the RS232 serial port is impossible, here is why: there is a flaw on the development board. When I bought my board, there was no communication to the unit. I thought the serial chip was bad and went to replace it. I discovered there is a serious flaw on the board. TX1 IN (PIN 11) is connected to TX2 OUT (PIN 7). It appears it should be connected to the pin opposite to it (PIN 10) which is TX2 IN. I removed the SP232 chip and cut the trace to Pin 7 (TX2OUT) under the SP232. Now the unit functions OK. 2) Some documentation mentions that the TU60-D120 (note 120 not 125 - there is no docs on the 125 out there) series is supposed to default to survey mode followed by position hold (best for time measurements). This does not occur with the unit I bought - a TU60-D125. You must put the unit into binary communication mode (@@Wb command at 9600 8N1) and then use 1255 command to set it to survey mode and then onto position hold. You use this command to configure the unit as a TRAIM receiver. (By the way, when you use the @@Wb command to switch serial protocols, it will immediately start spitting out data. Look for the 1056 message and it will tell you what mode the unit is in - and that survey mode on power up is DISABLED!!) 3) If you configure the unit with the 1255 command, it will NOT remember this configuration after power cycle - despite the function of the 1255 command is supposed to do this. So you need to do this each time you power up. That is, it will start out in the mode where it only responds to the @@XX commands and you must use @@Wb to switch over to the binary mode. And the use the 1255 command to command it into survey mode. After 24hrs (or what ever time you choose) it will transition to position hold and work to specs. I am comparing the output with a homebrew (yes, I mean it) WWVB receiver and getting delta F's comparing the 1PPS timing outputs of >1E-11 on average. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
