The TymServe TS2100 arrived this afternoon. So I started with the GPS receiver swap (update).
I removed the Trimble ACE III receiver (39818-C), but noted that this specific unit had a "widget board" (65398.69) on the SMA antenna connector and 2 wires (DC power) to the 3-pin header on the main board. Was this board used to support +12 VDC powered outdoor antennas? ---- Installed the Heol N024-TS-V2.1 receiver (ACE III clone w/corrections) and connected a Trimble 28367-00 GPS antenna (small mag mount) to the receiver's antenna port. >From a dead cold start, in urban canyons, I had tracking in about a minute and >lock in about 20 minutes. So far, so good. Next will be the TCXO to OCXO >conversion (MTI 240-0530-D). greg w9gb Sent from iPad Air _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
